Code Alarm Professional Series CA 1050 Manuel d'utilisateur télécharger pdf (Page 8)

12. Auto-Power-On/O

An automatic system turns the machine functions on and o automatically.

When one of the three work programs is selected by pressing the P1, P2 or P3 button, the following functions

are temporarily activated: center brush, suction motor, side brushes. The LED of the chosen program and the

center brush LED come on at the same time. If the accelerator pedal is not pressed, after a few seconds the

functions shut down and the three LEDS start ashing. The sweeper is now in AUTOPOWER- OFF mode. All

functions are automatically reactivated when the user presses the accelerator pedal: AUTO-POWER-ON.

NOTE: When the accelerator is released all the machine functions are automatically switched o.

13. Using the Work Programmes

After turning on the machine choose among the three available programs, the one best suiting your

requirements by pressing one of the three keys.

BUTTON 1 (Light cleaning, indoors, concrete, quartz, smooth oors, etc.)

BUTTON 2 (Medium cleaning, carpet or other surfaces)

BUTTON 3 (Heavy duty cleaning, outdoors, asphalt or rough surfaces with rubble, etc.).

NOTE: the parameters of programs 1, 2 and 3 are factory set. To modify any of the settings, contact the retailer’s

service center.

Adjust maximum forward movement speed according to the working conditions

Lower the left and/or right side brush by pulling out and lowering the relevant knob.

NOTE: the relevant left or right indicator light will come on.

To move the brushes back to their OFF position, pull up the knobs.

The speed of the side brushes can be changed using the adjustment knob shown in the gure.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Code Alarm Professional Series CA 1050 Manuel d'utilisateur Page 8