Code Alarm ca6153 Guide d'installation télécharger pdf (Page 24)

24 ca6153 revA

Tach Programming

The unit will not operate unless tach is programmed or tachless option is

turned ON. If an attempt is made to start the vehicle via the remote start without

first programming tach, the unit will flash the parking lights 7 times indicating tach

has not been learned and stored. If the tach rate is not properly programmed to

the specific vehicle, the unit may not realize that the vehicle is running in certain

instances and reengage the starter motor.

The Remote Start unit will learn the tach rate of most vehicle's single coil, multiple coil

packs, or single injector. To learn tach:

1. Turn the ignition key to the ON position.

2. Press and release the valet/override button 3 times.

3. Immediately turn the ignition key OFF.

4. Press and hold the valet/override button, then start the vehicle using

the key.

5. When the unit senses the tach signal, the parking lights will begin to

flash.

6. Allow the vehicle to settle to a normal idle speed.

7. Release the valet/program push-button switch. The parking lights will

turn on for 2 seconds and 1 long chip will indicate that the learned

tach signal is stored and the unit has exited tach learn mode.

NOTE: If the unit fails to learn tach rate due to an improper tach connection or a

poor tach source, the parking lights will not flash. To correct this situation, locate

and connect the PURPLE/WHITE wire to the proper tach signal, and then repeat

the tach learn routine.

Smart Tachless Mode

Smart Tachless Mode is available only if a tach signal has never been learned to

the system and when activated will automatically change the Tach Mode feature

in option programming to Tachless without the need to enter the feature

programming mode.

1. Activate the remote start. The parking lights should begin flashing 7

times indicating no tach signal has been learned.

2. Within the 7 flash time period, press and hold the

button.

3. The system will chirp 1 time indicating the system is now in tachless

mode.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Pas de commentaire

Code Alarm ca6153 Guide d'installation Page 24