Code Alarm PC 7400 Spécifications télécharger pdf (Page 33)

8.4 Disarming from the Master Keypad

Disarming all the

Partitions you

have access to.

Disarming from the Master Keypad

Enter your PIN followed by the [Off] key.

This will disarm all of your partitions, even if some are already disarmed.

You must enter Single Partition Mode to disarm the necessary partitions one at a time.

Disarming only

some of your

Partitions

1. Enter your [PIN], followed by the [#] key twice: [1] [2] [3] [4] [#] [#].

2. The first partition you have access to will be displayed:

"Armed. Cafeteria."

3. Complete the disarming command sequence for this partition: [Off].

4. Move to the next partition you have access to by pressing the [#] key twice: [#] [#].

5. The next partition you have access to will be displayed:

"Armed. Office."

6. Complete the disarming command sequence for this partition.

7. After you have disarmed all the partitions you have access to, exit Single Partition

Mode by pressing the [*] key for 2 seconds.

8.5 Single Partition Mode

Single Partition Mode is used to control partitions on a “one at a time/one by one” basis from the Master keypad.

To enter the Single Partition Mode, enter your [PIN], then press the [#] key twice. This will call up the first partition you have access to. Enter

the command sequence you wish for this partition. You do not need to use your PIN again. To move on to the next partition you have access

to, press the [#] key twice.

To exit the Single Partition Mode, hold the [*] key down for 2 seconds. The system will automatically drop out of Single Partition Mode after

40 seconds without a keypad entry.

8.6 Volume and Backlight Controls

The keypad sounder and display backlight (on the DS7447/DS7447E) may be adjusted at the keypad.

• Volume Control. The keypad sounder volume can be adjusted using the [1] and [4] keys along with the [*] key.

- Hold down the [*] key while pressing the [1] key to increase the volume or the [4] key to decrease the volume.

• Backlight Control. DS7447/DS7447E only. The backlight can be adjusted using the [3] and [6] keys along with the [*] key.

- Hold down the [*] key while pressing the [3] key to increase the brightness or the [6] key to decrease the brightness.

After the backlight and volume are adjusted, you must arm and disarm the control panel once to store the information in the

control panel. If power is disconnected before the panel is armed, the backlight and volume levels will return to the default

settings.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 91 92

Pas de commentaire

Code Alarm PC 7400 Spécifications Page 33