Code Alarm PC 7500 Manuel de l'opérateur télécharger pdf (Page 16)

When the Patient Security mode is enabled, operators cannot change

SpO

or Pulse Rate limits or Alarm Volume—though it is still possible to

view those settings. In Patient Security mode, operators cannot view or

set the time and date.

When the Model 7500 is turned on in Patient Security mode, “SEC on”

is displayed in the display area, and three informational tones sound. The

upper alarm limits are then displayed, followed by the lower alarm limits.

NOTE: Patient memory cannot be cleared when the Model 7500 is in Patient

Security mode. In addition, Patient Security mode is not disabled when the unit is

turned off.

Viewing and Changing Patient Security Mode

To enter Patient Security mode, press and hold the Alarm Silence button

while turning on the device. To exit Patient Security mode, press and hold

the Alarm Silence and Limits buttons while turning on the device.

When the device is restarted, the Patient Security mode status is

displayed on the Numeric LEDs for 1 second:

•“SEC on” is displayed when Patient Security mode is enabled.

•“

SEC oFF” is displayed when Patient Security mode is

disabled.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 44 45

Pas de commentaire

Code Alarm PC 7500 Manuel de l'opérateur Page 16